The M29F080D is a 8 Mbit (1Mb x8) non-volatile
memory that can be read, erased and repro-
grammed. These operations can be performed us-
ing a single low voltage 5V supply. On power-up
the memory defaults to its Read mode where it can
be read in the same ...
The M29W008D is a 8 Mbit (1Mb x 8) non-volatile
Flash memory that can be read, erased at block
multi-block or chip level and programmed at Byte
level. These operations are performed using a sin
gle 2.7V to 3.6V VCC supply voltage. For Program
and Erase ...
The M29W800D is a 8 Mbit (1Mb x8 or 512Kb x16) non-volatile memory that can be read,
erased and reprogrammed. M29W800DB, M29W800DT These operations can be performed using a single low voltage
(2.7 to 3.6V) supply. On power-up the memory defaults to its ...
The M29W800FT/M29W800FB is an 8 Mbit (1 Mb 8 or 512 Kb 16) non-volatile memory that can b
read, erased and reprogrammed. These operations can be performed using a single low
voltage (2.7 V to 3.6 V) supply. On power-up the memory defaults to its Read mode ...
The M50FLW080 is a 8 Mbit (1M x8) non-volatile memory M50FLW080A, M50FLW080B that can be read, erased and
reprogrammed. These operations can be performed using a single low voltage (3.0 to 3.6V)
supply. For fast programming and fast erasing on production ...
The M50FW080 is an 8 Mbit (1Mbit x8) non-volatile memory that can be read, erased and
reprogrammed. These operations can be performed using a single low voltage (3.0 to 3.6V)
supply. For fast programming and fast erasing in production lines an optional 12V ...
The M59DR008 is an 8 Mbit non-volatile Flash
memory M59DR008E, M59DR008F that may be erased electrically at block
level and programmed in-system on a Word-by-
Word basis using a 1.65V to 2.2V VDD supply for
the circuitry. For Program and Erase ...
The M25PE80 is an 8 Mbit (1 Mb 8) Serial Paged Flash memory accessed by a high
speed SPI-compatible bus.
The memory can be written or programmed 1 to 256 Bytes at a time, using the Page Write
or Page Program instruction. The Page Write instruction ...
The M45PE80 is a 8 Mbit (1 Mbit 8 bit) Serial Paged Flash Memory accessed by a high
speed SPI-compatible bus.
The memory can be written or programmed 1 to 256 bytes at a time, using the Page Write or
Page Program instruction. The Page Write instruction ...
The AT45DB081B is a 2.5-volt or 2.7-volt only, serial interface Flash memory ideally
suited for a wide variety of digital voice-, image-, program code- and data-storage
applications. Its 8,650,752 bits of memory are organized as 4096 pages of 264 ...
8M bit, 2.5 or 2.7-Volt Only Serial-Interface Flash The AT45DB081D is a 2.5V or 2.7V, serial-interface Flash memory ideally suited for a
wide variety of digital voice-, image-, program code- and data-storage applications.
The AT45DB081D supports RapidS ...
The AT26DF081A is a serial interface Flash memory device designed for use in a
wide variety of high-volume consumer-based applications in which program code is
shadowed from Flash memory into embedded or external RAM for execution. The
flexible erase ...
The AT25DF081 is a serial interface Flash memory device designed for use in a wide
variety of high-volume consumer based applications in which program code is shad-
owed from Flash memory into embedded or external RAM for execution. The flexible
erase ...
The AT49SV802A
AT49SV802AT is a 1.8-volt 8-megabit Flash memory organized as 524,288
words of 16 bits each or 1,048,576 bytes of 8 bits each. The x16 data appears on
I/O0 - I/O15; the x8 data appears on I/O0 - I/O7. The memory is divided into 23 ...
The AT49BV802D
AT49BV802DT is a 2.7-volt 8-megabit Flash memory organized as 524,28
words of 16 bits each or 1,048,576 bytes of 8 bits each. The x16 data appears o
I/O0 - I/O15; the x8 data appears on I/O0 - I/O7. The memory is divided into 23 ...
The MX23L8051 is a CMOS 8,338,608 bit serial Mask
ROM, which is configured as 1,048,576 x 8 internally. The
MX23L8051 features a serial peripheral interface and
software protocol allowing operation on a simple 3- wire
bus. The three bus signals are a ...
The MX25L8005 is a CMOS 8,388,608 bit serial Flash memory, which is configured as 1,048,576 x 8 internally. The
MX25L8005 feature a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus. The three
bus signals are a clock ...
The MX25V8005 is a CMOS 8,388,608 bit serial Flash memory, which is configured as 1,048,576 x 8 internally. The
MX25V8005 feature a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus. The three
bus signals are a clock ...
The S25FL008A is a 3.0 Volt (2.7 V to 3.6 V), single-power-supply Flash memory device. The device consists
of 16 sectors, each with 512 Kb memory.
The device accepts data written to SI (Serial Input) and outputs data on SO (Serial Output). The devices are ...
The A29800 is a 5.0 volt only Flash memory organized as
1048,576 bytes of 8 bits or 524,288 words of 16 bits each.
The A29800 offers the RESET function. The 1024 Kbytes of
data are further divided into nineteen sectors for flexible
sector erase ...
The A29L008 is an 8Mbit, 3.0 volt-only Flash memory
organized as 1,048,576 bytes. The data appear on I/O0 - I/O7.
The A29L008 is offered in 40-pin TSOP package. This
device is designed to be programmed in-system with the
standard system 3.0 volt VCC ...
The A29L008A is an 8Mbit, 3.0 volt-only Flash memory
organized as 1,048,576 bytes. The data appear on I/O0 - I/O7.
The A29L008A is offered in 40-pin TSOP package. This
device is designed to be programmed in-system with the
standard system 3.0 volt VCC ...
The A29L800A is an 8Mbit, 3.0 volt-only Flash memory
organized as 1,048,576 bytes of 8 bits or 524,288 words of 16
bits each. The 8 bits of data appear on I/O0 - I/O7; the 16 bits of
data appear on I/O0~I/O15. The A29L800A is offered in 48-ball
TFBGA, ...
The A25L80P is an 8 Mbit (1M x 8) Serial Flash Memory,
with advanced write protection mechanisms, accessed by a
high speed SPI-compatible bus.
The memory can be programmed 1 to 256 bytes at a time,
using the Page Program instruction.
The memory ...
The A25L080/A25L040 are 8M/4M bit Serial Flash Memory,
with advanced write protection mechanisms, accessed by a
high speed SPI-compatible bus.
The memory can be programmed 1 to 256 bytes at a time,
using the Page Program instruction.
The memory ...
The M25PE20 and M25PE10 are 2 Mbit (256 Kb 8 bit) and 1 Mbit (128 Kb 8 bit) serial
paged Flash memories, respectively. They are accessed by a high speed SPI-compatible
bus. ...
The M45PE80 is a 8 Mbit (1 Mbit 8 bit) Serial Paged Flash Memory accessed by a high
speed SPI-compatible bus.
The memory can be written or programmed 1 to 256 bytes at a time, using the Page Write or
Page Program instruction. The Page Write instruction ...
The M29F800D is a 8 Mbit (1Mb x8 or 512Kb x16)
non-volatile memory that can be read, erased and
reprogrammed. These operations can be per-
formed using a single low voltage (5V) supply. On
power-up the memory defaults to its Read mode
where it can be read ...
The W39V080A is an 8-megabit, 3.3-volt only CMOS flash memory organized as 1M 8 bits. For
flexible erase capability, the 8Mbits of data are divided into 16 uniform sectors of 64 Kbytes. The
device can be programmed and erased in-system with a standard ...
The W39V080FA is an 8-megabit, 3.3-volt only CMOS flash memory organized as 1M 8 bits. For
flexible erase capability, the 8Mbits of data are divided into 16 uniform sectors of 64 Kbytes. The device
can be programmed and erased in-system with a standard ...