AAT4650 | 5V/3V PC Card Power Switch

The AAT4650 SmartSwitch is a single-channel PC Card (PCMCIA) power Switch It is used to select between two different voltage inputs, each between 2.7V and 5.5V. An internal Switch powers the circuitry from whichever input voltage is higher. The device's output, VCC, is slew rate controlled and Current Limited in compliance with PC Card specifications. The current limit response time to a short circuit is typically 1s. The internal P-Channel MOSFET switches are configured to break before make; that is, both switches cannot be closed at the same time. Controlled by a 2-bit parallel Interface the four states for VCC are VCC5, VCC3, Hi-impedance, or Ground. When in the Ground state, VCC is pulled to Ground by a 5k resistor. An open drain FAULT output is asserted during over-current conditions. During power-up slewing, FAULT also signals that VCC is out of tolerance. An internal over-temperature Sensor forces VCC to a high impedance state when an over-temperature condition exists. Quiescent current is typically a low 15A, as long as ICC is less than approximately 500mA; above this load current, the quiescent current increases to 200A. The AAT4650 is available in an 8-pin SOP or TSSOP package specified over the -40 to +85C temperature range.
By Advanced Analogic Technologies, Inc.
AAT4650 's PackagesAAT4650 's pdf datasheet
AAT4650IAS-T1
AAT4650IHS-T1




AAT4650 Pinout, Pinouts
AAT4650 pinout,Pin out
This is one package pinout of AAT4650,If you need more pinouts please download AAT4650's pdf datasheet.

AAT4650 Application circuits
AAT4650 circuits
This is one application circuit of AAT4650,If you need more circuits,please download AAT4650's pdf datasheet.


Related Electronics Part Number

Related Keywords:

AAT4650 Pb-Free AAT4650 Cross Reference AAT4650 Schematic AAT4650 Distributor
AAT4650 Application Notes AAT4650 RoHS AAT4650 Circuits AAT4650 footprint