1:10 DDR Phase-Lock Loop Clock Driver
The CDCV857 is a high-performance, low-skew, low-jitter zero delay Buffer that distributes a differential Clock input pair (CLK, CLK) to ten differential pairs of Clock outputs (Y[0:9], Y[0:9]) and one differential pair of feedback Clock output (FBOUT, FBOUT). The Clock outputs are controlled by the Clock inputs (CLK, CLK), the feedback Clocks (FBIN, FBIN), and the Analog power input (AVDD). When PWRDWN is high, the outputs Switch in phase and frequency with CLK. When PWRDWN is low, all outputs are disabled to high impedance state (3-state), and the PLL is shut down (low power mode). The device also enters this low power mode when the input frequency falls below a suggested detection frequency that is below 20 MHz (typical 10 MHz). An input frequency detection circuit will detect the low frequency condition and after applying a >20 MHz input signal this detection circuit turns on the PLL again and enables the outputs.
When AVDD is strapped low, the PLL is turned off and bypassed for test purposes. The CDCV857 is also able to track spread spectrum clocking for reduced EMI
Since the CDCV857 is based on PLL circuitry, it requires a stabilization time to achieve phase-lock of the PLL This stabilization time is required following power up. The CDCV857 is characterized for operation from 0C to 85C.
By Texas Instruments
|CDCV857 Pb-Free||CDCV857 Cross Reference||CDCV857 Schematic||CDCV857 Distributor|
|CDCV857 Application Notes||CDCV857 RoHS||CDCV857 Circuits||CDCV857 footprint|