MAX9961, MAX9962 Dual, Low-Power, 500Mbps ATE Drivers/Comparators With 2mA Load

The MAX9961 MAX9962 dual, low-power, high-speed, pin electronics driver Comparator load (DCL) ICs include, for each channel, a three-level pin driver, a dual Comparator variable clamps, and an active load. The driver features a wide voltage range and high-speed operation, includes high-impedance and active-termination (3rd-level drive) modes, and is highly linear even at low voltage swings. The dual Comparator provides low dispersion (timing variation) over a wide variety of input conditions. The clamps provide damping of high-speed device-under-test (DUT) waveforms when the device is configured as a high-impedance receiver. The programmable load supplies up to 2mA of source and sink current. The load facilitates contact/continuity testing and pullup of high-output-impedance devices.
The MAX9961A/MAX9962A provide tight matching of offset for the drivers and the Comparators allowing reference levels to be shared across multiple channels in cost-sensitive systems. Use the MAX9961B/MAX9962B for system designs that incorporate independent reference levels for each channel.
The MAX9961 MAX9962 provide high-speed, differential control inputs compatible with LVPECL, LVDs and GTL. The MAX9961 MAX9962 are available with optional internal termination resistors. The open-collector Comparator outputs are available with or without internal pullup resistors. The optional internal resistors significantly reduce the Discrete component count on the circuit board.
A 3-wire, low-voltage, CMOS-compatible serial Interface programs the low-leakage, slew-rate limit, and tri-state/ terminate operational configurations of the MAX9961 MAX9962.
The MAX9961 MAX9962s' operating range is -1.5V to +6.5V with power dissipation of only 900mW per channel. The devices are available in a 100-pin, 14mm x 14mm body, and 0.5mm pitch TQFP. An exposed 8mm x 8mm die pad on the top MAX9961 or bottom MAX9962 of the package facilitates efficient heat removal. The device is specified to operate with an internal die temperature of +70C to +100C, and features a die temperature monitor output.
By Maxim Integrated Products
MAX9962 's PackagesMAX9962 's pdf datasheet



MAX9962 Pinout, Pinouts
MAX9962 pinout,Pin out
This is one package pinout of MAX9962,If you need more pinouts please download MAX9962's pdf datasheet.

MAX9962 circuits will be updated soon..., now you can download the pdf datasheet to check the circuits!

Related Electronics Part Number

Related Keywords:

MAX9962 Pb-Free MAX9962 Cross Reference MAX9962 Schematic MAX9962 Distributor
MAX9962 Application Notes MAX9962 RoHS MAX9962 Circuits MAX9962 footprint