Hot-Swap SiP With Active EMI Filter

The QPI-7 is the low-voltage version of the QPI-8 SiP product that includes the total Hot Swap function with an EMI Filter for DC/DC converter applications. The EMI Filter provides active conducted common-mode (CM) and differential- mode (DM) noise attenuation over the CISPR22 frequency range of 150 kHz to 30 MHz. The QPI-7 is designed for use on a 24 volt DC bus. The in-rush current limit and circuit breaker are designed to deliver over 100 W of power over the typical 24 V converter operating range of 18 to 36 V. The QPI-7 €™s internal fault Timer allows it to operate safely in the event of a short across its output. The QPI-7 enters a retry mode where it will attempt to restart until the short condition is removed. The under and over voltage thresholds CAN be trimmed separately via the UVEN and OV inputs using external series resistors. The Power Good active high output provides opto-coupler drive for a converterā€™s active low enable (See Fig. 9a) or active high by connecting the Diode in series with the PWRGD output (See Figure 9b). The QPI-7 is available in a 25 mm x 25 mm x 4.5 mm SiP (System in Package) with LGA mounting. QPI-EVAL1 kits are available with a mounted QPI-7 with screw terminals for easy insertion and testing. Check www.picorpower.com for the data sheet. By Vicor Corp.
QPI-7 's PackagesQPI-7 's pdf datasheet
QPI-7LZ-01
QPI-7LZ




QPI-7 Pinout, Pinouts
QPI-7 pinout,Pin out
This is one package pinout of QPI-7,If you need more pinouts please download QPI-7's pdf datasheet.

QPI-7 Application circuits
QPI-7 circuits
This is one application circuit of QPI-7,If you need more circuits,please download QPI-7's pdf datasheet.


Related Electronics Part Number

Related Keywords:

QPI-7 Pb-Free QPI-7 Cross Reference QPI-7 Schematic QPI-7 Distributor
QPI-7 Application Notes QPI-7 RoHS QPI-7 Circuits QPI-7 footprint