PROFIBUS RS-485 Transceiver
These devices is a half-duplex differential transceiver, with cha c73 racteristics optimized for use in PROFIBUS (EN 50170) applications. The driver output differential voltage exceeds the Profibus requirements of 2.1 V with a 54- load. A signaling rate of up to 40 Mbps allows technology growth to high data transfer speeds. The low bus capacitance provides low signal distortion.
The SN65HVD1176 and SN75HVD1176 meet or exceed the requirements of ANSI standard TIA/EIA-485-A (RS-485) for differential data transmission across twisted-pair networks. The driver outputs and receiver inputs are tied together to form a half-duplex bus port, with one-fifth unit load, allowing up to 160 nodes on a single bus. The receiver output stays at Logic high when the bus lines are shorted, left open, or when no driver is active. The driver outputs are in high impedance when the supply voltage is below 2.5 V to prevent bus disturbance during power cycling or during live insertion to the bus.
An internal current limit protects the transceiver bus pins in short-circuit fault conditions by limiting the output current to a constant value. Thermal shutdown circuitry protects the device against damage due to excessive power dissipation caused by faulty loading and drive conditions.
The SN75HVD1176 is characterized for operation at temperatures from 0C to 70C. The SN65HVD1176 is characterized for operation at temperatures from ?40C to 85C.
By Texas Instruments
|SN75HVD1176DR||Texas Instruments||PROFIBUS RS-485 Transceiver 8-SOIC 0 to 70|
|SN75HVD1176DG4||Texas Instruments||PROFIBUS RS-485 Transceiver 8-SOIC 0 to 70|
|SN75HVD1176DRG4||Texas Instruments||PROFIBUS RS-485 Transceiver 8-SOIC 0 to 70|
|SN75HVD1176D||Texas Instruments||PROFIBUS RS-485 Transceiver 8-SOIC 0 to 70|
|SN75HVD1176 Pb-Free||SN75HVD1176 Cross Reference||SN75HVD1176 Schematic||SN75HVD1176 Distributor|
|SN75HVD1176 Application Notes||SN75HVD1176 RoHS||SN75HVD1176 Circuits||SN75HVD1176 footprint|