TDA5360 Pre-amplifier For Hard Disk Drive With MR-Read / Inductive Write Heads

The +/- 5.0 volt pre-amplifier for HDD described here has been designed for 12 terminals, comprised of a SAL or GMR magneto-resistive reader and an inductive thin film writer. In read mode, the device operates as a low noise differential preamplifier which senses resistance changes in the MR element that correspond to flux changes on the disk. In write mode, the circuit operates as a thin film head current switchdriving the inductive element of the head. The IC incorporates Read Amplifiers with programmable gain and HF boosts, Write Amplifiers 3-wires Serial Interface digital-to-analog Converters, Thermal Asperity Detector and Programmable Thermal Asperity Compresso, rreference and control circuits which operate on a Dual Supply Voltage of +/-5V (+/-10%).The Read Amplifier has programmable medium input impedance. The DC offset between the two terminals of the MR head is eliminated using on chip AC coupling. The bandwidth CAN be enhanced by using programmable high frequency gain-boost. Fast settling features are used to keep the transients short. As an option, the Read Amplifier may be left biased during writing, so as to reduce the duration of these transients even further.The Write Amplifier has a programmable current overshoot which may be added to the programmable steady state write current.Fault protection is provided for a variety of read or write unsafe conditions. For added data protection, internal pull up resistors are connected to RWN, CS0,CS1,STWN, WDP and WDN pins and pull down resistors are connected to SEN, SDATA, SCLK, DRN and BFAST pins, to prevent accidental writing due to open lines and to ensure the device will power up in a non-writing condition. On-chip Digital to Analog converters for MR bias current or power and Write current are programmed via a 3 wire Serial Interface Head selection, Mode control, Testing and Servo Writing CAN also be programmed using the serial Interface In Sleep mode,the CMOS serial Interface is operationnal. . Invalid head select codes disable the writer, select the dummy head and trigger the FLT output.
By NXP Semiconductors
TDA5360 's PackagesTDA5360 's pdf datasheet



TDA5360 Pinout will be updated soon..., now you can download the pdf datasheet to check the pinouts !
TDA5360 circuits will be updated soon..., now you can download the pdf datasheet to check the circuits!

Related Electronics Part Number

Related Keywords:

TDA5360 Pb-Free TDA5360 Cross Reference TDA5360 Schematic TDA5360 Distributor
TDA5360 Application Notes TDA5360 RoHS TDA5360 Circuits TDA5360 footprint
Hot categories