TDA8083 Satellite Demodulator And Decoder (SDD3)

This document specifies a DVB compliant Demodulator and forward error correction decoder IC for reception of QPSK or BPSK modulated signals for satellite applications. The Satellite Demodulator and Decoder (SSD) CAN handle variable symbol rates without adapting the Analog Filters within the Tuner Typical applications for this device are:MCPC (Multi-Channel Per Carrier): one QPSK or BPSK modulated signal in a single satellite channel (transponder)Simul-cast: QPSK or BPSK modulated signal together with a Frequency Modulated (FM) signal in a single satellite channel (transponder).The TDA8083 CAN handle variable symbol rates in the range of 12 to 30 Msymbols/s with a minimum number of low cost and non-critical external components.The TDA8083 has minimal Interfaces with the Tuner It only requires the demodulated Analog I and Q baseband input signals and provides a Tuner AGC control signal. Analog-to-digital conversion is done internally by two matched 7-bit ADCs The TDA8083 runs on a low frequency crystal which is upconverted to a Clock frequency by means of an internal PLL Furthermore, the TDA8083 has an internal anti-alias Filter which CAN cover the range of symbol frequencies without the need to Switch external (SAW) Filters The TDA8083 has a double Carrier loop configuration which has excellent capabilities of tracking phase noise. Synchronization of the FEC unit is done completely internally, thereby minimizing IC-bus Communication The output of the TDA8083 allows different output modes (parallel or serial) to Interface to a demultiplexer, descrambler or MPEG-2 decoder including a 3-state mode. For evaluation of the TDA8083 Demodulator and Viterbi decoder outputs CAN be made available externally.The SDD CAN be controlled and monitored by the IC-bus. A 5-bit bidirectional I/O expander and an interrupt line are available. By sending an interrupt signal, the SDD CAN inform the Microcontroller of its internal status. Separate resets are available for Logic only, Logic plus the IC-bus and Carrier loops. A switchable IC-bus loop-through to the Tuner is implemented to Switch off the IC-bus connection to the Tuner This reduces phase noise in the Tuner in case of IC-bus crosstalk.Furthermore, for dish control applications hardware supports DiSEqC 1.X and Tone burst generation via IC-bus control. A 22 or a 44 kHz Carrier CAN be generated (tone mode).
By NXP Semiconductors
TDA8083 's PackagesTDA8083 's pdf datasheet



TDA8083 Pinout, Pinouts
TDA8083 pinout,Pin out
This is one package pinout of TDA8083,If you need more pinouts please download TDA8083's pdf datasheet.

TDA8083 circuits will be updated soon..., now you can download the pdf datasheet to check the circuits!

Related Electronics Part Number

Related Keywords:

TDA8083 Pb-Free TDA8083 Cross Reference TDA8083 Schematic TDA8083 Distributor
TDA8083 Application Notes TDA8083 RoHS TDA8083 Circuits TDA8083 footprint