TJA1020 LIN Transceiver

The TJA1020 is the Interface between the LIN master/slave protocol controller and the physical bus in a Local Interconnect Network (LIN). It is primarily intended for in-vehicle sub-networks using baud rates from 2.4 up to 20 Kbaud. The transmit data stream of the protocol controller at the TXD input is converted by the LIN transceiver into a bus signal with controlled slew rate and wave shaping to minimize EME. The LIN bus output pin is pulled HIGH via an internal termination resistor. For a master application an external resistor in series with a Diode should be connected between pin INH or pin BAT and pin LIN The receiver detects the data stream at the LIN bus input pin and transfers it via pin RXD to the Microcontroller In normal transceiver operation the TJA1020 CAN be switched in the normal slope mode or the low slope mode. In the low slope mode the TJA1020 lengthens the rise and fall slopes of the LIN bus signal, thus further reducing the already very low emission in normal slope mode. In sleep mode the power consumption of the TJA1020 is very low, whereas in failure modes the power consumption is reduced to a minimum.
By NXP Semiconductors
TJA1020 's PackagesTJA1020 's pdf datasheet
TJA1020T-N1 SO
TJA1020U-N1




TJA1020 Pinout, Pinouts
TJA1020 pinout,Pin out
This is one package pinout of TJA1020,If you need more pinouts please download TJA1020's pdf datasheet.

TJA1020 Application circuits
TJA1020 circuits
This is one application circuit of TJA1020,If you need more circuits,please download TJA1020's pdf datasheet.


Related Electronics Part Number

Related Keywords:

TJA1020 Pb-Free TJA1020 Cross Reference TJA1020 Schematic TJA1020 Distributor
TJA1020 Application Notes TJA1020 RoHS TJA1020 Circuits TJA1020 footprint
Hot categories