PWM Controller With Wide Input Voltage Range
The TL5001 and TL5001A incorporate on a single monolithic chip all the functions required for a pulse-width-modulation (PWM) control circuit. Designed primarily for power-supply control, the TL5001 A contains an error Amplifier a Regulator an Oscillator a PWM Comparator with a dead-time-control input, undervoltage lockout (UVLO), short-circuit protection (SCP), and an open-collector output Transistor The TL5001A has a typical reference voltage tolerance of 3% compared to 5% for the TL5001.
The error-amplifier common-mode voltage ranges from 0 V to 1.5 V. The noninverting input of the error Amplifier is connected to a 1-V reference. Dead-time control (DTC) CAN be set to provide 0% to 100% dead time by connecting an external resistor between DTC and GND. The Oscillator frequency is set by terminating RT with an external resistor to GND. During low VCC conditions, the UVLO circuit turns the output off until VCC recovers to its normal operating range.
The TL5001C and TL5001AC are characterized for operation from ?20C to 85C. The TL5001I and TL5001AI are characterized for operation from ?40C to 85C. The TL5001Q and TL5001AQ are characterized for operation from ?40C to 125C. The TL5001M and TL5001AM are characterized for operation from ?55C to 125C.
By Texas Instruments
|TL5001AMFK||Texas Instruments||IC 0.1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, CQCC20, CERAMIC, LCC-20, Switching Regulator or Controller|
|TL5001AMFKB||Texas Instruments||PWM Controller with Wide Input Voltage Range 20-LCCC -55 to 125|
|TL5001AMJG||Texas Instruments||PWM Controller with Wide Input Voltage Range 8-CDIP -55 to 125|
|TL5001AMJGB||Texas Instruments||PWM Controller with Wide Input Voltage Range 8-CDIP -55 to 125|
|TL5001AM Pb-Free||TL5001AM Cross Reference||TL5001AM Schematic||TL5001AM Distributor|
|TL5001AM Application Notes||TL5001AM RoHS||TL5001AM Circuits||TL5001AM footprint|