4 Channel 18 Bit Transceiver 500mbps To 1.3Gbps

The TLK4120 is a four channel multi-gigabit transceiver used in high-speed bidirectional point-to-point data transmission systems. The TLK4120 supports an effective serial Interface speed of 0.5 Gbps to 1.3 Gbps per channel, providing up to 1.17 Gbps of data bandwidth per channel.
The primary application of the TLK4120 is to provide high-speed I/O data channels for point-to-point baseband data transmission over controlled impedance media of approximately 50 . The transmission media CAN be printed-circuit board, copper cables, or fiber-optic cable. The maximum rate and distance of data transfer is dependent upon the attenuation characteristics of the media and the noise coupling to the environment.
The TLK4120 CAN also be used to replace parallel data transmission architectures by providing a reduction in the number of traces, connector pins, and transmit/receive pins. Parallel data loaded into the transmitter is delivered to the receiver over a serial channel, which CAN be a coaxial copper cable, a controlled impedance Backplane or an optical link. The data is then reconstructed into its original parallel format. It offers significant power and cost savings over current solutions, as well as scalability for higher data rate in the future.
The TLK4120 performs the data parallel-to-serial, serial-to-parallel conversion, and Clock extraction functions for a physical layer Interface device. The serial transceiver Interface operates at a maximum speed of 1.3 Gbps. The transmitter Latches 18-bit parallel data at a rate based on the supplied reference Clock (GTx_CLK). The 18-bit parallel data is internally encoded into 20 bits by framing the 18-bit data with a start and a stop bit. The resulting 20-bit word is then transmitted differentially at 20 times the reference Clock (GTx_CLK) rate. The receiver section performs the serial-to-parallel conversion on the input data, synchronizing the resulting 20-bit wide parallel data to the recovered Clock (Rx_CLK). It then extracts the 18 bits of data from the 20-bit wide data resulting in 18 bits of parallel data at the receive data pins (RDx[0:17]). This results in an effective data payload of 0.45 Gbps to 1.17 Gbps (18 bits data x GTx_CLK frequency).
The TLK4120 is designed to be hot plug capable. An on-chip power-on reset circuit holds the Rx_CLK low and places the parallel side output signal pins, DOUTTXP and DOUTTXN, into a high-impedance state during power up.
The TLK4120 uses a 2.5-V supply. The I/O section is 3-V compatible. With the 2.5-V supply, the TLK4120 is power efficient, consuming less than 1150 mW typically. The TLK4120 is characterized for operation from -40C to 85C.
By Texas Instruments
TLK4120 's PackagesTLK4120 's pdf datasheet
TLK4120IGPV BGA
TLK4120IZPV BGA




TLK4120 Pinout will be updated soon..., now you can download the pdf datasheet to check the pinouts !
TLK4120 circuits will be updated soon..., now you can download the pdf datasheet to check the circuits!

Related Electronics Part Number

Related Keywords:

TLK4120 Pb-Free TLK4120 Cross Reference TLK4120 Schematic TLK4120 Distributor
TLK4120 Application Notes TLK4120 RoHS TLK4120 Circuits TLK4120 footprint
Hot categories