Fast, Synchronous-Buck MOSFET Drivers With 8V Drive Regulator

The TPS2838 39/48/49 devices are MOSFET drivers designed for high-performance synchronous power supplies. The drivers CAN source and sink up to 4-A peak current at a 14-V drive voltage. These are ideal devices to use with power supply controllers that do not have on-chip drivers. The low-side driver is capable of driving loads of 3.3 nF in 10-ns rise/fall times and has 40-ns propagation delays at room temperature.
The MOSFET drivers have an integrated 150-mA Regulator so the Gate drive voltage CAN be optimized for specific MOSFETs The TPS2848 and TPS2849 have a fixed 8-V drive Regulator while the TPS2838 39 allow the drive Regulator to be adjusted from 4 V to 14 V by selection of two external resistors.
The devices feature VDRV to PGND shoot-through protection with adaptive/adjustable deadtime control. The deadtime, for turning on the high-side FET from LOWDR transitioning low, is adjustable with an external capacitor on the DELAY pin. This allows compensation for the effect the Gate resistor has on the synchronous FET turn off. The adaptive deadtime prevents the turning on of the low-side FET until the voltage on the BOOTLO pin falls below a threshold after the high-side FET stops conducting. The high-side drive CAN be configured as a ground referenced driver or a floating bootstrap driver. The internal Schottky Diode minimizes the size and number of external components needed for the bootstrap driver circuit. Only one external ceramic capacitor is required to configure the bootstrap driver.
The SYNC pin CAN be used regardless of load to disable the synchronous FET driver and operate the power supply nonsynchronously.
A power ready/undervoltage lockout function outputs the status of the VCC-pin voltage and driver Regulator output on the open-drain PWRRDY pin. This feature CAN be used to enable a controllers output once the VCC voltage reaches the threshold and the Regulator output is stable. This function ensures both FET drivers are off when the VCC voltage is below the voltage threshold.
The TPS2838 39/48/49 devices are offered in the thermally enhanced 14-pin and 16-pin PowerPAD TSSOP package. The PowerPAD package features an exposed leadframe on the bottom that CAN be soldered to the printed-circuit board to improve thermal efficiency. The TPS2838 48 are noninverting control Logic while the TPS2839 49 drivers are inverting control Logic
By Texas Instruments
Part Manufacturer Description Datasheet Samples
TPS2849PWP Texas Instruments Fast, Synchronous-Buck MOSFET Drivers With 8V Drive Regulator 14-HTSSOP -40 to 125
TPS2849PWPRG4 Texas Instruments 4.4A HALF BRDG BASED MOSFET DRIVER, PDSO14, 5.10 X 6.60 MM, GREEN, PLASTIC, HTSSOP-14
TPS2849PWPG4 Texas Instruments 4.4A HALF BRDG BASED MOSFET DRIVER, PDSO14, 5.10 X 6.60 MM, GREEN, PLASTIC, HTSSOP-14
TPS2849 's PackagesTPS2849 's pdf datasheet
TPS2849PWP HTSSOP
TPS2849PWPG4 HTSSOP
TPS2849PWPR HTSSOP
TPS2849PWPRG4 HTSSOP




TPS2849 Pinout, Pinouts
TPS2849 pinout,Pin out
This is one package pinout of TPS2849,If you need more pinouts please download TPS2849's pdf datasheet.

TPS2849 Application circuits
TPS2849 circuits
This is one application circuit of TPS2849,If you need more circuits,please download TPS2849's pdf datasheet.


Related Electronics Part Number

Related Keywords:

TPS2849 Pb-Free TPS2849 Cross Reference TPS2849 Schematic TPS2849 Distributor
TPS2849 Application Notes TPS2849 RoHS TPS2849 Circuits TPS2849 footprint