TZA1046 Photodiode And Amplifier IC For CD Ad DVD Applications

The TZA1046 is a single optical pick-up IC for read/write systems and is suitable for CD and DVD applications. The device contains eight RF Amplifiers for the central and satellite Diodes and one differential RF Amplifier (RFP and RFN) which handles the sum of the four A, B, C and D central Diode signals. Programming the gain is a very versatile way to optimize interfacing between the TZA1046 and the preamplifier. The gain CAN be programmed for CD or DVD media with the gain Switch CD/DVD. The H/L Switch is a three level Switch that CAN be used to adjust the gain for different dye and phase change media. The third level (high-impedance state) invokes the power-down mode for standby condition. Gain Switch R/W is used to reduce the gain during writing. During CD-R writing with clipping, the high peak signals for the central and satellite segments are clamped internally and the output currents of the A, B, C, D, E, F, G and H segments are folded back to reduce power consumption. The output currents CAN be folded back to almost zero, depending on the light power detected. CD-R writing CAN also be done without clipping for applications where averaging is used. All outputs are current outputs that CAN supply a maximum of 8 mA. In CD-R write clip mode, the clipping level of the output currents is between 5 mA and 8 mA. The HTSSON16T package has a low spread on the Z tolerance. The Z tolerance is measured between the Diodes (chip surface) and the bottom of the leads. The Diodes have an offset of 54 um the y direction with respect to the leadframe centre and a tolerance of 50um in both x- and y-directions. In normal operation the satellite outputs F and H are combined as one output FH and the satellite outputs E and G are combined as one output EG. In normal mode the ETST and HTST outputs are not used (high ohmic). When pulling the R/W pin above the supply or is left open the device comes into a testing mode where all four separate satellite channels are directed to the outputs. This mode is used for Optical Pick-up Unit (OPU) alignment of the Diodes where all satellite channels must be available.
By NXP Semiconductors
TZA1046 's PackagesTZA1046 's pdf datasheet



TZA1046 Pinout, Pinouts
TZA1046 pinout,Pin out
This is one package pinout of TZA1046,If you need more pinouts please download TZA1046's pdf datasheet.

TZA1046 Application circuits
TZA1046 circuits
This is one application circuit of TZA1046,If you need more circuits,please download TZA1046's pdf datasheet.


Related Electronics Part Number

Related Keywords:

TZA1046 Pb-Free TZA1046 Cross Reference TZA1046 Schematic TZA1046 Distributor
TZA1046 Application Notes TZA1046 RoHS TZA1046 Circuits TZA1046 footprint