UAA2068AHL Transmit Chain And Synthesizer With Integrated VCO For DECT

The UAA2068AHL BiCMOS device integrates a 950 MHz VCO a frequency doubler, main and reference dividers and a phase Comparator to implement a phase-locked loop for DECT channel frequencies. The 1.9 GHz signal is buffered and switched, in TX mode, to drive the transmit power Amplifier (CGY20xx series) or, in RX mode, to be used as an LO signal for the receiver mixer IC (UAA3540TS).The synthesizer,s main divider is driven by the frequency doubler output in the range from 1880 to 1920 MHz and programmed via a 3-wire serial bus.The reference divider ratio is fixed at 16. Outputs of the main and reference dividers drive a phase Comparator where a Charge Pump produces phase error current pulses for integration in an external loop Filter Only a passive loop Filter is necessary. The charge-pump current (phase Comparator gain) is set by an external resistor (RSET) at pin RSET.The VCO is powered from an internally regulated voltage source and includes internal varicap Diodes Its tuning range is wider than the required band to allow for production spreads. In a Time Division Multiple Access (TDMA) system such as DECT, the VCO and the synthesizer are switched on one slot before the required one to lock the VCO to the required channel frequency. Just before the required slot, the synthesizer is switched off, allowing open-loop modulation of the VCO during transmission. When opening the loop, the frequency pulling (due to switching off the synthesizer) CAN be maintained within the DECT specification.The device is designed to operate from 3 NiCd cells in pocket phones, with low current and nominal 3.6 V supplies. Separate power and ground pins are provided to the different parts of the circuit. The ground leads should be short-circuited externally to prevent large currents flowing across the die and thus causing damage. All supply pins (VCC) must also be at the same potential, except VCC(CP) which CAN be equal to or greater than the other supply pins (e.g. VCC = 3 V and VCC(CP) = 5 V for wider VCO control voltage range).
By NXP Semiconductors
UAA2068AHL 's PackagesUAA2068AHL 's pdf datasheet



UAA2068AHL Pinout, Pinouts
UAA2068AHL pinout,Pin out
This is one package pinout of UAA2068AHL,If you need more pinouts please download UAA2068AHL's pdf datasheet.

UAA2068AHL Application circuits
UAA2068AHL circuits
This is one application circuit of UAA2068AHL,If you need more circuits,please download UAA2068AHL's pdf datasheet.


Related Electronics Part Number

Related Keywords:

UAA2068AHL Pb-Free UAA2068AHL Cross Reference UAA2068AHL Schematic UAA2068AHL Distributor
UAA2068AHL Application Notes UAA2068AHL RoHS UAA2068AHL Circuits UAA2068AHL footprint