UAA3522HL Low Power Dual-band GSM Transceiver With An Image Rejecting Front-end

The UAA3522HL integrates the receiver and most of the transmitter section of a GSM hand-held transceiver. It also integrates the receiver IF and the transmitter section of a DCS transceiver.The receiver comprises an RF and an IF section. The RF (GSM) front-end amplifies the aerial signal, converts the chosen channel frequency to an IF of 200 MHz, and also provides more than 30 dB of image suppression. Some selectivity is provided at this stage by an off-chip bandpass pre-filter. The IF section further amplifies the chosen channel, maintains the gain at the required level, demodulates the signal into I and Q components, and provides channel selectivity at a baseband stage using a high performance integrated low-pass Filter The IF gain CAN be varied over a range of more than 60 dB. The offset at the I and Q outputs CAN be cancelled out by software using the 3-wire serial programming bus.The input Low Noise Amplifier (LNA) CAN be switched off via the bus to allow accurate calibration in the offset cancellation mode.The transmitter comprises a high precision I/Q Modulator and modulation loop architecture. The I/Q Modulator converts the baseband modulation frequency to the transmit IF. The modulation loop architecture, which includes an on-chip offset mixer and phase detector, controls an external transmit RF VCO which converts the transmit modulated IF signal to RF.A receive RF VCO provides the Local Oscillator (LO) signal to the image rejection mixers in the RF Receiver An IF VCO provides the LO signal to the I/Q Demodulator and I/Q Modulator in the receiver and transmitter sections respectively.The frequencies of the RF VCO and the IF VCO are set by internal PLL circuits, which are programmable via the 3-wire serial bus. The RF and IF PLL comparison frequencies are 200 kHz and 1 MHz respectively, derived from a 13 MHz reference signal which has to be supplied externally. The quadrature RF LO signals required by the image rejection mixers are obtained using on-chip Resistor Capacitor (RC) networks. The quadrature IF LO signals required by the I/Q Modulator and I/Q Demodulator are obtained by dividing the frequency of the IF VCO signal.The IC CAN be powered on in either receiver (RX), transmitter (TX) or synthesizer (SYN) operating mode depending on the Logic level at pins RXON, TXON and SYNON, respectively. Alternatively, an operating mode CAN be selected by software using the 3-wire serial programming bus. In RX or TX mode, only those sections of the IC which are required are switched on.The GSM or DCS band is selected by the 3-wire serial programming bus. When activating RX mode for DCS applications, the receiver RF section CAN be disabled by software so that only the receiver IF section is powered-on.The SYN mode is used to power-on the synthesizer prior to activating the RX or TX mode. In SYN mode, some internal LO Buffers are also powered-on to minimize the ,pulling, effect of the VCO when either the receiver or the transmitter are switched on.
By NXP Semiconductors
UAA3522HL 's PackagesUAA3522HL 's pdf datasheet



UAA3522HL Pinout, Pinouts
UAA3522HL pinout,Pin out
This is one package pinout of UAA3522HL,If you need more pinouts please download UAA3522HL's pdf datasheet.

UAA3522HL Application circuits
UAA3522HL circuits
This is one application circuit of UAA3522HL,If you need more circuits,please download UAA3522HL's pdf datasheet.


Related Electronics Part Number

Related Keywords:

UAA3522HL Pb-Free UAA3522HL Cross Reference UAA3522HL Schematic UAA3522HL Distributor
UAA3522HL Application Notes UAA3522HL RoHS UAA3522HL Circuits UAA3522HL footprint