BiCMOS PFC/PWM Combination Controller
The UCC2850x family provides all of the control functions necessary for an active power-factor-corrected preregulator and a second-stage dc-to-dc converter. The controller achieves near-unity power factor by shaping the ac input line current waveform to correspond to the ac input-line voltage using average current-mode control. The dc-to-dc converter uses peak current-mode control to perform the Step-down power conversion.
The PFC stage is leading-edge modulated while the second stage is trailing-edge synchronized to allow for minimum overlap between the boost and PWM switches. This reduces ripple current in the bulk-output capacitor.In order to operate with over three-to-one range of input-line voltages, a line feedforward (VFF) is used to keep input power constant with varying input voltage. Generation of VFF is accomplished using IAC in conjunction with an external single-pole Filter This not only reduces external parts count, but also avoids the use of High-Voltage components, offering a lower-cost solution. The multiplier then divides the line current by the square of VFF.
The UCC2850x PFC section incorporates a low offset-voltage Amplifier with 7.5-V reference, a highly-linear multiplier capable of a wide current range, a high-bandwidth, low offset-current Amplifier with a novel noise-attenuation configuration, PWM Comparator and latch, and a high-current output driver. Additional PFC features include over-voltage protection, zero-power detection to turn off the output when VAOUT is below 0.33 V and peak current and power limiting.
The dc-to-dc section relies on an error signal generated on the secondary-side and processes it by performing peak current mode control. The dc-to-dc section also features current limiting, a controlled soft-start, preset operating range with selectable options, and 50% maximum duty cycle.
The UCC28500 and UCC28502 have a wide PFC-UVLO threshold (16.5 V/10 V) for bootstrap bias supply operation. The UCC28501 and UCC28503 are designed with a narrow UVLO range (10.5 V/10 V) more suitable for fixed bias operation. The UCC28500 and UCC28501 have a narrow UVLO threshold for PWM stage (to allow operation down to 75% of nominal bulk voltage), while the UCC28502 and UCC38503 are configured for a much wider operation range for the PWM stage (down to 50% of bulk nominal voltage).
Available in 20-pin N and DW packages.
By Texas Instruments
|UCC38503NG4||Texas Instruments||BiCMOS PFC/PWM Combination Controller 20-PDIP 0 to 70|
|UCC38503DWTRG4||Texas Instruments||BiCMOS PFC/PWM Combination Controller 20-SOIC 0 to 70|
|UCC38503DWG4||Texas Instruments||BiCMOS PFC/PWM Combination Controller 20-SOIC 0 to 70|
|UCC38503DW||Texas Instruments||1A POWER FACTOR CONTROLLER WITH POST REGULATOR, PDSO20, SOIC-20|
|UCC38503N||Texas Instruments||BiCMOS PFC/PWM Combination Controller 20-PDIP 0 to 70|
|UCC38503DWTR||Texas Instruments||1.2A POWER FACTOR CONTROLLER WITH POST REGULATOR, 120kHz SWITCHING FREQ-MAX, PDSO20, GREEN, PLASTIC, SOIC-20|
|UCC38503 Pb-Free||UCC38503 Cross Reference||UCC38503 Schematic||UCC38503 Distributor|
|UCC38503 Application Notes||UCC38503 RoHS||UCC38503 Circuits||UCC38503 footprint|