Digital Control Compatible Synchronous-Buck Gate Driver With Current Sense And Fault Protection

The UCD7231 high current driver is specifically designed for digitally-controlled, point-of-load, synchronous buck switching power supplies. Two driver circuits provide high charge and discharge current for the high-side NMOS Switch and the low-side NMOS synchronous Rectifier in a synchronous buck circuit. The MOSFET Gates are driven to +6 V by an internally regulated VGG supply. The internal VGG Regulator CAN be disabled to permit the user to supply their own Gate drive voltage. This flexibility allows a wide power conversion input voltage range of 2.2 to 15 V. Internal under voltage lockout (UVLO) Logic insures VGG is good before allowing chip operation. A drive Logic block allows operation in one of two modes selected by the SRE Mode pin. In Synchronous Mode, the Logic block uses the PWM signal to control both the high-side and low-side Gate drive signals. Dead time is automatically adjusted to prevent cross conduction. The Synchronous Rectifier Enable (SRE) pin controls whether or not the low-side FET is turned on when the PWM signal is low. In Independent Mode, the PWM and SRE pins control the high-side and low-side Gates directly. No anti-cross-conduction Logic is used in this mode. On-board Comparators monitor the voltage across the high side Switch and the voltage across an external Current Sense element to safeguard the power stage from sudden high current loads. Blanking delay is set for the high side Comparator by a single resistor in order to avoid false reports coincident with switching edge noise. In the event of a high-side fault or an over-current fault, the high-side FET turned off and the Fault Flag (FLT) is asserted to alert the digital controller. The fault thresholds are independently set by the HS Sense and ILIM pins. By Texas Instruments
Part Manufacturer Description Datasheet Samples
UCD7231RTJT Texas Instruments Digital Control Compatible Synchronous Buck Gate Driver with Current Sense and Fault Protection 20-QFN -40 to 125
UCD7231RTJR Texas Instruments Digital Control Compatible Synchronous Buck Gate Driver with Current Sense and Fault Protection 20-QFN -40 to 125
UCD7231 's PackagesUCD7231 's pdf datasheet
UCD7231RTJR QFN
UCD7231RTJT QFN




UCD7231 Pinout, Pinouts
UCD7231 pinout,Pin out
This is one package pinout of UCD7231,If you need more pinouts please download UCD7231's pdf datasheet.

UCD7231 Application circuits
UCD7231 circuits
This is one application circuit of UCD7231,If you need more circuits,please download UCD7231's pdf datasheet.


Related Electronics Part Number

Related Keywords:

UCD7231 Pb-Free UCD7231 Cross Reference UCD7231 Schematic UCD7231 Distributor
UCD7231 Application Notes UCD7231 RoHS UCD7231 Circuits UCD7231 footprint